Note:
For TR modules with OS 3.05D or higher, use CATS Service Tools as a RF programmer.
RF Programming Ctrl+F6
Activate/deactivate the RF Programming function. For more info see IQRF OS User's Guide - Appendix 3: RFPGM – RF Programming™. RF programming is automatically activated if the RF programmer is connected (note). An information about connected RF programmer is shown (if given warning is active). This setting is mutually connected with checkbox in the Project window.
End RF Programming F12
Send the command for connected RF programmer to exit RF programming mode in remote TR modules being programmed. This item is active only if RF Programming mode is activated and RF programmer is connected.
Create CATS RF Programmer
Creates the CATS service tool from connected TR module. This is the same feature like the Create CATS button in the CATS Service Tools window.
Remove CATS
Removes the CATS from connected TR module. This is the same feature like the Remove CATS button in the CATS Service Tools window.
Upload RFPGMCK_STANDARD plug-in into TR module (note). After uploading an information about connected RF programmer is shown (if given warning is active).
Create RF Programmer Lite
Upload RFPGMCK_LITE plug-in into TR module (note). After uploading an information about connected RF programmer is shown (if given warning is active).
Remove RF Programmer
Remove RFPGMCK plug-in from TR module. This item is active only if a TR module with the RFPGMCK plug-in is connected (note).