IQMESH implementation enables to read and/or write the complete TR configuration or to change any parameter (RF channel, RX filter, …) in an existing network. This can be performed in the Coordinator, in a single selected Node, or all Nodes at the same time. The changes will come into effect not until the given device (Coordinator, Node) is reset.
|
Caution: Some parameters (e.g. the operating RF channel) have a crucial influence on the functionality of the whole IQMESH network. Therefore, an improper change can cause the complete malfunction of the network. |
If a parameter should be changed in the whole network, proceed as follows:
● Change the parameter in all Nodes
● Restart the Nodes
● Change the parameter in the Coordinator
● Restart the Coordinator
The TR configuration read/write is implemented as a service (a group of DPA commands) available in IQRF IDE or IQRF GW Daemon.