Writes multiple bytes (or just bits) to the TR Configuration memory. This command is for advanced users only. The Acknowledged broadcast is recommended for writing configuration values to all or selected Nodes as it also confirms which Nodes performed the configuration write. Please note that the device should be restarted for some configuration changes to take effect. See TR Configuration for details.
Request
|
NADR |
PNUM |
PCMD |
HWPID |
0 |
1 |
2 |
… |
n × 3 |
n × 3 + 1 |
n × 3 + 2 |
|
NADR |
0x02 |
0x09 |
? |
Address0 |
Value0 |
Mask0 |
… |
Addressn |
Valuen |
Maskn |
n ∈ [0,17] Number of configuration items to write minus 1.
Address Address of the item at configuration memory block. The valid address range is 0x00-0x1F for configuration values. Also, address 0x20 is a valid value for RFPGM settings. See the parameter of setupRFPGM IQRF OS function.
Value Value of the configuration item to write.
Mask Specifies bits of the configuration item (i.e. byte) to be modified by the corresponding bits of the Value parameter. Only bits that are set at the Mask will be written to the configuration byte i.e. when Mask equals 0xFF then the whole Value will be written to the configuration byte. For example, when Mask equals 0x12 then only bit.1 and bit.4 from Value will be written to the configuration byte.
Response
The general response to writing request with STATUS_NO_ERROR Error code.
Error codes
ERROR_DATA Address is out of range.