IQRF OS: 3.06D-0707 (DCTR-5xD)
Changes and enhancements
• Foursome parameters NAdr, PNum, PCmd capitalized to NADR, PNUM, and PCMD.
• Foursome parameter HwProfile renamed to HWPID.
• Updated timing recommendation, see DPA Confirmation.
• DpaEvent_None event renamed to DpaEvent_DpaRequest.
• CMD_OS_SLEEP – Control bit 0 and bit 3 functionality enhanced and changed.
• Brown-out Reset disabled after the device starts.
• Extra 32 bytes added to both EEPROM and EEEPROM peripherals.
• IQRF OS variable DataOutBeforeResponseFRC type changed from uns16 to uns8[30].
• System DPA value bit 0 returns value of DSMactivated variable.
• DpaApiSendToIFaceMaster has a new parameter.
• User DPA Value is stored at the UserDpaValue variable. It is not transferred via userReg0 variable at the Idle event only anymore.
• Set Hops does not limit the number of hops to the VRN of the addressed and discovered Node anymore.
• UART interface uses more sophisticated 8-bit CRC instead of simple XOR checksum to protect data.
• DpaApiSendToIFaceMaster works even when IFaceMasterNotConnected is set in the case when the UART interface is used.
• DpaApiRfTxDpaPacketCoordinator now returns a number of hops to deliver DPA Request back to the Coordinator.
New features
• Full low-power (LP) support (i.e. bonding, Discovery, and FRC).
• FRC Acknowledged Broadcast.
• Custom DPA Handler auto-detection.
• IO Setup (early Autoexec).
• Extra 32 bytes memory space added to EEPROM and external EEPROM peripherals.
Bug fixes
• Fixed an issue when NADR did not contain original sender address at (1.) DpaEvent_Notification event at the [C] device or (2.) inside the Batch request.
• Fixed an issue when NADR did not contain recipient address at DpaEvent_DpaRequest event when DPA Request was part of Batch (or Autoexec) request.
• Fixed an issue with the [C] device where the asynchronous or local requests might not be executed (because of internal HWPID variable was not initialized) until enumeration of [C] peripherals was performed.
• Fixed an issue where at CMD_OS_SLEEP wake up on pin did not work when the calibration was initiated too (always the 1st time the CMD_OS_SLEEP was requested).
• Fixed an issue when using CMD_IO_SET as a part of Autoexec or CMD_OS_BATCH might cause device malfunction.
• Flushing internal buffers of SPI or UART before calling IQRF OS functions that use shared bufferCOM or when the device is going to sleep or reset.
• Improved disabling/enabling SPI/UART peripherals/interfaces before calling IQRF OS functions that use shared bufferCOM or when the device is going to sleep or reset.