This command sets the voltage of the 0-10 V lighting analog interface (LAI). The response returns the previous value.
Request
|
NADR |
PNUM |
PCMD |
HWPID |
0 … 1 |
|
NADR |
0x4A |
0x02 |
0xXXXX |
CtrlSignal |
CtrlSignal The desired voltage at LAI at the Extra-low Voltage format. If the value is 0x8000 then the voltage is not set. If the value is out of the interval 0-10 V then ERROR_FAIL is returned.
Response
|
NADR |
PNUM |
PCMD |
HWPID |
ErrN |
DpaValue |
0 … 1 |
|
NADR |
0x4A |
0x82 |
0xXXXX |
0 |
? |
CtrlSignal |
CtrlSignal Voltage at the LAI at the Extra-low Voltage format before the request was received.