[sync] This command is implemented at the [N] devices only. The command controls the device indication (by default visual). The indication is usually used during inventory or device localization. By default, the command uses both (red and green) default IQRF LEDs at (or connected to) the [N].
The default indication behavior can be changed using an Indicate event. The custom indication can be visual (a light), acoustic (a buzzer), action (a motor), etc.
Request
|
NADR |
PNUM |
PCMD |
HWPID |
0 |
|
NADR |
0x02 |
0x07 |
? |
Control |
Control bits.0-1 0b00 Indication is switched off.
0b01 Indication is switched on [*].
0b10 Indication is on for 1 s [**].
0b11 Indication is on for 10 s [**].
[*] The default LED indication will be immediately off at [N] at LP mode. Use timed indication at LP [N] devices instead.
[**] During the indication, the [N] is blocked and any network traffic will not be processed.
bits.2-7 Reserved.
Response
The general response to writing request with STATUS_NO_ERROR Error code.